NETGEAR ProSafe GSM7224P User Manual page 40

no auto-negotiate all
This command disables automatic negotiation on all ports.
Format
no auto-negotiate all
Mode
Global Config
description
Use this command to create an alpha-numeric description of the port.
Format
description <description>
Mode
Interface Config
mtu
Use the mtu command to set the maximum transmission unit (MTU) size, in bytes, for frames
that ingress or egress the interface. You can use the mtu command to configure jumbo frame
support for physical and port-channel (LAG) interfaces. For the standard 7000 series
implementation, the MTU size is a valid integer between 1522 - 9216 for tagged packets and
a valid integer between 1518 - 9216 for untagged packets.
Note: To receive and process packets, the Ethernet MTU must include any
extra bytes that Layer-2 headers might require. To configure the IP
MTU size, which is the maximum size of the IP packet (IP Header +
IP payload), see
Default
1518 (untagged)
Format
mtu <1518-9216>
Mode
Interface Config
no mtu
This command sets the default MTU size (in bytes) for the interface.
Format
no mtu
Mode
Interface Config
shutdown
This command disables a port.
ProSafe Managed Switch
ip mtu on page 242.
Switching Commands
40