NETGEAR ProSafe GSM7224P User Manual page 458

Prosafe managed switch command line interface (cli) 9.0.2

Hide thumbs Also See for ProSafe GSM7224P:

Table of Contents

conditions of more than one class, preference is based on the order in which you add the

classes to the policy. The first class you add has the highest precedence.

This set of commands consists of policy creation/deletion, class addition/removal, and

individual policy attributes.

The only way to remove an individual policy attribute from a class

instance within a policy is to remove the class instance and re-add it

to the policy. The values associated with an existing policy attribute

can be changed without removing the class instance.

The CLI command root is policy-map.

assign-queue

This command modifies the queue id to which the associated traffic stream is assigned. The

queueid is an integer from 0 to n-1, where n is the number of egress queues supported by

assign-queue <queueid>

Policy-Class-Map Config

Incompatibilities

This command specifies that all packets for the associated traffic stream are to be dropped at

Policy-Class-Map Config

Incompatibilities

Assign Queue, Mark (all forms), Mirror, Police, Redirect

This command specifies that all incoming packets for the associated traffic stream are copied

to a specific egress interface (physical port or LAG).

mirror <unit/slot/port>

Policy-Class-Map Config

Incompatibilities

Drop, Redirect

ProSafe Managed Switch

Quality of Service (QoS) Commands

Show Quick Links

Chapters

Table of Contents