Open Shortest Path First (Ospf) Commands; Router Ospf - NETGEAR ProSafe GSM7224P User Manual

Term Definition
DHCP server
The number of DHCP responses received from the DHCP server. This count
messages received
includes only messages that the DHCP server unicasts to the relay agent for relay
to the client.
DHCP server
The number of DHCP server messages relayed to a client.
messages relayed
UDP clients
The number of valid UDP packets received. This count includes DHCP messages
messages received
and all other protocols relayed. Conditions are similar to those for the first statistic in
this table.
UDP clients
The number of UDP packets relayed. This count includes DHCP messages relayed
messages relayed
as well as all other protocols. The count is incremented for each server to which a
packet is sent.
DHCP message hop
The number of DHCP client messages received whose hop count is larger than the
count exceeded max
maximum allowed. The maximum hop count is a configurable value listed in show
bootpdhcprelay. A log message is written for each such failure. The DHCP relay
agent does not relay these packets.
DHCP message with
The number of DHCP client messages received whose secs field is less than the
secs field below min
minimum value. The minimum secs value is a configurable value and is displayed in
show bootpdhcprelay. A log message is written for each such failure. The DHCP
relay agent does not relay these packets.
DHCP message with
The number of DHCP client messages received whose gateway address, giaddr, is
giaddr set to local
already set to an IP address configured on one of the relay agent's own IP
address
addresses. In this case, another device is attempting to spoof the relay agent's
address. The relay agent does not relay such packets. A log message gives details
for each occurrence.
Packets with expired
The number of packets received with TTL of 0 or 1 that might otherwise have been
TTL
relayed.
Packets that
The number of packets ignored by the relay agent because they match a discard
matched a discard
relay entry.
entry

Open Shortest Path First (OSPF) Commands

This section describes the commands you use to view and configure OSPF, which is a
link-state routing protocol that you use to route traffic within a network.

router ospf

Use this command to enter Router OSPF mode.
Format
router ospf
Mode
Global Config
ProSafe Managed Switch
Routing Commands
268