Configuring The Switch Management Cpu - NETGEAR ProSafe GSM7224P User Manual

Configuring the Switch Management CPU

To manage the switch via the web GUI or telnet, an IP address needs to be assigned to the
switch management CPU. Whereas there are CLI commands that can be used to do this,
ezconfig simplifies the task. The tool is applicable to all NETGEAR 7000-series managed
switches, and allows you to configure the following parameters:
1. The administrator's user password and administrator-enable password
2. Management CPU IP address and network mask
3. System name and location information
The tool is interactive and uses questions to guide you through the steps required to perform
its task. At the end of the session, it will ask you if you want to save the changed information.
To see exactly what has been changed by ezconfig at the end of the session, use the show
running-config command.
To perform any switch configuration other than the items listed above, use other CLI
commands or the Web GUI.
ezconfig
This command sets the IP address, subnet mask and gateway of the device. The IP address
and the gateway must be on the same subnet.
Format
ezconfig
Mode
Privileged EXEC
ProSafe Managed Switch
Management Commands
589