Ip Pim Rp-Candidate; Ip Pim Spt-Threshold - NETGEAR ProSafe GSM7224P User Manual

ip pim rp-candidate

This command is used to configure the router to advertise itself as a PIM candidate
rendezvous point (RP) to the bootstrap router (BSR).
Default
None
Format
ip pim rp-candidate interface interface <interface-num>
<group-address> <group-mask>}
Mode
Global Config
no ip pim rp-candidate
This command is used to disable the router to advertise itself as a PIM candidate rendezvous
point (RP) to the bootstrap router (BSR).
Format
no ip pim rp-candidate interface interface <interface-num>
<group-address> <group-mask>}
Mode
Global Config

ip pim spt-threshold

This command is used to configure the Data Threshold rate for the last-hop router to switch
to the shortest path. The rate is specified in Kilobits per second. The possible values are 0 to
2000.
Default
0
Format
ip pim spt-threshold <0-2000>
Mode
Global Config
Note: Non-Zero Data Threshold Rate is currently not supported on this
platform. Only Switch on First Packet policy is supported.
no ip pim spt-threshold
This command is used to set the Data Threshold rate for the RP router to the default value.
Format
no ip pim spt-threshold
Mode
Global Config
ProSafe Managed Switch
IP Multicast Commands
335