Radius Server Retransmit; Radius Server Timeout - NETGEAR ProSafe GSM7224P User Manual

radius server retransmit

Use this command to configure the global parameter for the RADIUS client that specifies the
number of transmissions of the messages to be made before attempting the fall back server
upon unsuccessful communication with the current RADIUS authenticating server. When the
maximum number of retries are exhausted for the RADIUS accounting server and no
response is received, the client does not communicate with any other server.
Default
4
Format
radius server retransmit <retries>
Mode
Global Config
Field Description
retries
The maximum number of transmission attempts in the range of 1 to 15.
no radius server retransmit
Use this command to set the value of this global parameter to the default value.
Format
no radius server retransmit
Mode
Global Config

radius server timeout

Use this command to configure the global parameter for the RADIUS client that specifies the
timeout value (in seconds) after which a request must be retransmitted to the RADIUS server
if no response is received. The timeout value is an integer in the range of 1 to 30.
Default
5
Format
radius server timeout <seconds>
Mode
Global Config
Field Description
retries
Maximum number of transmission attempts in the range <1-30>.
no radius server timeout
Use this command to set the timeout global parameter to the default value.
Format
no radius server timeout
Mode
Global Config
ProSafe Managed Switch
Management Commands
644