Garp Commands; Show Private-Group; Set Garp Timer Join - NETGEAR ProSafe GSM7224P User Manual

default, the mode is "community" mode that each member port can forward traffic to other
members in the same group, but not to members in other groups.
Format
private-group name <privategroup-name> [<groupid>] [mode {community|isolated}]
Mode
Global Config
no private-group name
This command is used to remove the specified private group.
Format
private-group name <privategroup-name>
Mode
Global Config

show private-group

This command displays the private groups' information.
Format
show private-groupname [<private-group-name>|<private-group-id>|port <unit/slot/port>]
Mode
Privileged EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
Port VLANID
The VLAN ID associated with the port.
Private Group
Total number of private groups is 192.
ID
Private Group
The name string can be up to 24 bytes of non-blank characters
Name
Private Group
The mode can be either "isolated" or "community".

GARP Commands

This section describes the commands you use to configure Generic Attribute Registration
Protocol (GARP) and view GARP status. The commands in this section affect both GARP
VLAN Registration Protocol (GVRP) and Garp Multicast Registration Protocol (GMRP).
GARP is a protocol that allows client stations to register with the switch for membership in
VLANS (by using GVMP) or multicast groups (by using GVMP).

set garp timer join

This command sets the GVRP join time for one port (Interface Config mode) or all (Global
Config mode) and per GARP. Join time is the interval between the transmission of GARP
Protocol Data Units (PDUs) registering (or re-registering) membership for a VLAN or
ProSafe Managed Switch
Switching Commands
85