Ipv6 Mld Commands; Show Ipv6 Pim Rp-Hash; Show Ipv6 Pim Rp Mapping - NETGEAR ProSafe GSM7224P User Manual

Term Definition
Next Bootstrap
Time (in hours, minutes, and seconds) in which the next bootstrap message is due
Message In
from this BSR.
Next Candidate
Time (in hours, minutes, and seconds) in which the next candidate RP advertisement
RP advertisement
will be sent.
in

show ipv6 pim rp-hash

Use this command to display which rendezvous point (RP) is being used for a specified
group.
Format
show ipv6 pim rp-hash <group-address>
Modes
• Privileged EXEC
• User EXEC
Term Definition
RP
The IP address of the RP for the group specified.
Origin
Indicates the mechanism (BSR or static) by which the RP was selected.

show ipv6 pim rp mapping

Use this command to display all group-to-RP mappings of which the router is aware (either
configured or learned from the bootstrap router (BSR)). If no RP is specified, all active RPs
are displayed.
Format
show ipv6 pim rp mapping [rp address]
Modes
• Privileged EXEC
• User EXEC

IPv6 MLD Commands

IGMP/MLD Snooping is Layer 2 functionality but IGMP/MLD are Layer 3 multicast protocols.
It requires that in a network setup there should be a multicast router (which can act as a
querier) to be present to solicit the multicast group registrations. However some network
setup does not need a multicast router as multicast traffic is destined to hosts within the same
network. In this situation, the 7000 series has an IGMP/MLD Snooping Querier running on
one of the switches and Snooping enabled on all the switches. For more information, see
IGMP Snooping Configuration Commands
page 172.
ProSafe Managed Switch
on page 161 and
IPv6 Multicast Commands
428
MLD Snooping Commands on