Chapter 8 Ipv6 Multicast Commands - NETGEAR ProSafe GSM7224P User Manual

IPv6 Multicast Commands
8.
This chapter describes the IPv6 multicast commands available in the managed switch CLI.
Note: Commands described in this chapter that require a license are:
IPv6 Multicast Forwarder Commands
IPv6 PIM Commands
IPv6 MLD Commands
IPv6 MLD-Proxy Commands
This chapter contains the following sections:
• IPv6 Multicast Forwarder Commands
• IPv6 PIM Commands
• IPv6 MLD Commands
• IPv6 MLD-Proxy Commands
The commands in this chapter are in three functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
• Clear commands clear some or all of the settings to factory defaults.
Note: There is no specific IP multicast enable for IPv6. Enabling of
multicast at global config is common for both IPv4 and IPv6.
on page 418
on page 420
on page 428
on page 434
417
8