Ospfv3 Commands; Ipv6 Ospf; Ipv6 Ospf Areaid - NETGEAR GSM7328Sv1 - ProSafe 24+4 Gigabit Ethernet L3 Managed Stackable Switch Cli Manual

Format
clear ipv6 statistics [{<unit/slot/port> | loopback <loopback-id> |
tunnel <tunnel-id>}]
Mode Privileged EXEC

OSPFv3 Commands

This section describes the commands you use to configure OSPFv3, which is a link-state routing
protocol that you use to route traffic within a network.

ipv6 ospf

This command enables OSPF on a router interface or loopback interface.
Default disabled
Format
ipv6 ospf
Mode Interface Config
no ipv6 ospf
This command disables OSPF on a router interface or loopback interface.
Format
no ipv6 ospf
Mode Interface Config

ipv6 ospf areaid

This command sets the OSPF area to which the specified router interface belongs. The <areaid>
is an IPv6 address, formatted as a 4-digit dotted-decimal number or a decimal value in the range of
<0-4294967295>. The <areaid> uniquely identifies the area to which the interface connects.
Assigning an area id, which does not exist on an interface, causes the area to be created with
default values.
Format
ipv6 ospf areaid <areaid>
Mode Interface Config
IPv6 Commands
Managed Switch CLI Manual, Release 8.0
v1.0, July 2009
7-33