Show Ip Vrrp Interface Brief - NETGEAR ProSafe GSM7224P User Manual

Term Definition
Configured
The priority configured through the ip vrrp <vrid> priority <1-254> command.
Priority
Advertisement
The advertisement interval in seconds for the specific virtual router.
interval
Pre-Empt Mode The preemption mode configured on the specified virtual router.
Administrative
The status (Enable or Disable) of the specific router.
Mode
State
The state (Master/backup) of the virtual router.
The following shows example CLI display output for the command.
(Switch)#show ip vrrp interface 1/0/1 1
Primary IP Address............................. 1.1.1.5
VMAC Address................................... 00:00:5e:00:01:01
Authentication Type............................ None
Priority....................................... 100
Configured priority.......................... 100
Advertisement Interval (secs).................. 1
Pre-empt Mode.................................. Enable
Administrative Mode............................ Disable
Accept Mode.................................... Enable
State.......................................... Initialized
Track Interface
---------------
<1/0/1>
TrackRoute (pfx/len)
------------------------
10.10.10.1/255.255.255.0

show ip vrrp interface brief

This command displays information about each virtual router configured on the switch. This
command takes no options. It displays information about each virtual router.
Format
show ip vrrp interface brief
Modes
• Privileged EXEC
• User EXEC
Term Definition
Interface
Valid slot and port number separated by forward slashes.
VRID
The router ID of the virtual router.
IP Address
The virtual router IP address.
ProSafe Managed Switch
State DecrementPriority
------ ------------------
down
State DecrementPriority
------ ------------------
down
Routing Commands
262
10
10