Traceroute Ipv6 - NETGEAR ProSafe GSM7224P User Manual

Parameter Description
count
Use the optional count parameter to specify the number of probes to send for each
TTL value. Range is 1 to 10 probes.
port
Use the optional port parameter to specify destination UDP port of the probe. This
should be an unused port on the remote destination system. Range is 1 to 65535.
size
Use the optional size parameter to specify the size, in bytes, of the payload of the
Echo Requests sent. Range is 0 to 65507 bytes.
Example: The following are examples of the CLI command.
traceroute Success:
(Switch) # traceroute 10.240.10.115 initTtl 1 maxTtl 4 maxFail 0 interval 1 count 3 port
33434 size 43
Traceroute to 10.240.10.115 ,4 hops max 43 byte packets:
1 10.240.4.1 708 msec
2 10.240.10.115 0 msec
Hop Count = 1 Last TTL = 2 Test attempt = 6 Test Success = 6
traceroute Failure:
(Switch) # traceroute 10.40.1.1 initTtl 1 maxFail 0 interval 1 count 3
port 33434 size 43
Traceroute to 10.40.1.1 ,30 hops max 43 byte packets:
1 10.240.4.1 19 msec
2 10.240.1.252 0 msec
3 172.31.0.9 277 msec
4 10.254.1.1 289 msec
5 10.254.21.2 287 msec
6 192.168.76.2 290 msec
7 0.0.0.0 0 msec *
Hop Count = 6 Last TTL = 7 Test attempt = 19 Test Success = 18

traceroute ipv6

Use the traceroute command to discover the routes that packets actually take when
traveling to their destination through the network on a hop-by-hop basis. The
<ipv6-address|hostname> parameter must be a valid IPv6 address or hostname. The
optional <port> parameter is the UDP port used as the destination of packets sent as part
of the traceroute. This port should be an unused port on the destination system. The range
for <port> is zero (0) to 65535. The default value is 33434.
Default
port: 33434
Format
traceroute ipv6 <ipv6-address|hostname> [port <port>]
Mode
Privileged EXEC
ProSafe Managed Switch
41 msec 11 msec
0 msec 0 msec
18 msec 9 msec
0 msec 1 msec
276 msec 277 msec
327 msec 282 msec
293 msec 296 msec
291 msec 289 msec
Utility Commands
528