Pre-Login Banner And System Prompt Commands; Script Validate; Copy (Pre-Login Banner); Set Prompt - NETGEAR ProSafe GSM7224P User Manual

script validate

Use this command to validate a script file by parsing each line in the script file, where
<scriptname> is the name of the script to validate.The validate option is intended to be
used as a tool for script development. Validation identifies potential problems. It might not
identify all problems with a given script on any given device.
Format
script validate <scriptname>
Mode
Privileged EXEC

Pre-login Banner and System Prompt Commands

This section describes the commands you use to configure the pre-login banner and the
system prompt. The pre-login banner is the text that displays before you login at the User:
prompt.

copy (pre-login banner)

Use a copy command option to upload or download the CLI Banner to or from the switch.
You can specify local URLs by using TFTP, Xmodem, Ymodem, or Zmodem.
Note: <ip6address> is also a valid parameter for routing packages that
support IPv6.
Default
none
Format
copy <Code Sample
Variable><tftp://<ipaddr>/<filepath>/<filename>><Code Sample
Variable> nvram:clibanner
copy nvram:clibanner <Code Sample
Variable><tftp://<ipaddr>/<filepath>/<filename>><Code Sample
Variable>
Mode
Privileged EXEC

set prompt

Use this command to change the name of the prompt. The length of name may be up to 64
alphanumeric characters.
Format
set prompt <prompt_string>
Mode
Privileged EXEC
ProSafe Managed Switch
Management Commands
657