Logging Email Urgent; Logging Email Message-Type To-Addr - NETGEAR ProSafe GSM7224P User Manual

level, but below the urgent severity level, are emailed in a non-urgent manner by collecting
them together until the log time expires. You can specify the severitylevel value as either an
integer from 0 to 7 or symbolically through one of the following keywords: emergency (0),
alert (1), critical (2), error (3), warning (4), notice (5), info (6), or debug (7).
Default
Disabled; when enabled, log messages at or above severity Warning (4) are emailed
Format
logging email [<severitylevel>]
Mode
Global Config
no logging email
This command disables email alerting.
Format
no logging email
Mode
Global Config

logging email urgent

This command sets the lowest severity level at which log messages are emailed immediately
in a single email message. Specify the severitylevel value as either an integer from 0 to 7 or
symbolically through one of the following keywords: emergency (0), alert (1), critical
(2), error (3), warning (4), notice (5), info (6), or debug (7). Specify none to indicate
that log messages are collected and sent in a batch email at a specified interval.
Default
Alert (1) and emergency (0) messages are sent immediately
Format
logging email urgent {<severitylevel> | none }
Mode
Global Config
no logging email urgent
This command resets the urgent severity level to the default value.
Format
no logging email urgent
Mode
Global Config

logging email message-type to-addr

This command configures the email address to which messages are sent. The message
types supported are urgent, non-urgent, and both. For each supported severity level,
multiple email addresses can be configured. The to-email-addr variable is a standard email
address, for example admin@yourcompany.com.
Format
logging email message-type {urgent |non-urgent |both}
to-addr <to-email-addr>
Mode
Global Config
ProSafe Managed Switch
Utility Commands
521