Show Poe - NETGEAR ProSafe GSM7224P User Manual

no poe traps
Use this command to disable logging the PoE traps.
Format
no poe traps
Mode Global Config

show poe

Use this command to get global information regarding the PoE status.
Format
show poe
Mode Privileged EXEC
User EXEC
Term Definition
Firmware Version This is the firmware version of the PoE controller on the switch.
PSE Main This indicates the status of the PoE controller:
Operational Status
• ON—Indicates that the PoE controller is actively delivering power.
• OFF—Indicates that the PoE controller is not delivering power.
• FAULTY—Indicates that the PoE controller is not functioning.
Total Power (Main This indicates the maximum amount of power that can be delivered by this PoE unit
AC) when on system power.
Total Power (RPS) This indicates the maximum amount of power that can be delivered by this PoE unit
when on RPS.
Total Power (PD) This indicates the maximum amount of power that can be delivered by this PoE unit
when on the PD source. This field is applicable only for the GSM5212P.
Power Source This indicates the power source being used: main AC, RPS, or PD. If PD is used as a
source, then "PD <portNo>" is displayed.
Threshold Power System can power up one port, if consumed power is less than this power. That is,
the consumed power can be between the total power and threshold power values.
The threshold power value is effected by changing the system usage threshold.
Total Power This indicates the total amount of power being delivered to all the devices plugged
Consumed into the switch.
Usage Threshold This indicates the usage threshold level.
Power This indicates the management mode used by the PoE controller.
Management
Mode
Auto Reset Mode This indicates whether the PoE ports will be automatically reset in case of an error on
a port.
Traps This configures the traps.
ProSafe Managed Switch
Power over Ethernet (PoE) Commands
497