Igmp Proxy Commands; Ip Igmp-Proxy - NETGEAR ProSafe GSM7224P User Manual

Term Definition
Querier Status
The status of the IGMP router, whether it is running in Querier mode or Non-Querier
mode.
Querier IP
The IP address of the IGMP Querier on the IP subnet to which this interface is attached.
Address
Querier Up Time
The time since the interface Querier was last changed.
Querier Expiry
The amount of time remaining before the Other Querier Present Timer expires. If the
Time
local system is the querier, the value of this object is zero.
Wrong Version
The number of queries received whose IGMP version does not match the IGMP version
Queries
of the interface.
Number of
The number of times a group membership has been added on this interface.
Joins
Number of
The current number of membership entries for this interface.
Groups

IGMP Proxy Commands

The IGMP Proxy is used by IGMP Router (IPv4 system) to enable the system to issue IGMP
host messages on behalf of hosts that the system discovered through standard IGMP router
interfaces. With IGMP Proxy enabled, the system acts as proxy to all the hosts residing on its
router interfaces.

ip igmp-proxy

This command enables the IGMP Proxy on the router. To enable the IGMP Proxy on the
router, you must enable multicast forwarding. Also, make sure that there are no multicast
routing protocols enabled on the router.
Format
ip igmp-proxy
Mode
Interface Config
no ip igmp-proxy
This command disables the IGMP Proxy on the router.
Format
no ip igmp-proxy
Mode
Interface Config
ProSafe Managed Switch
IP Multicast Commands
347