Ip Ospf Restart-Helper Strict-Lsa-Checking Status - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPF Commands

ip ospf restart-helper strict-lsa-checking status

Administratively enables and disables whether or not a changed Link State Advertisement (LSA) will
result in termination of graceful restart by a helping router.
ip ospf restart-helper strict-lsa-checking status {enable | disable}
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The minimum hardware configuration for this command is a redundant CMM configuration. This
command is not supported on OmniSwitch chassis-based switches with a single CMM or OmniSwitch
stackable switches in a standalone configuration.
•
On OmniSwitch 6850 switches, a graceful restart is supported only on active ports (i.e., interfaces) that
are on the secondary or idle modules in a stack during a takeover. It is not supported on ports on a
primary switch in a stack.
Examples
-> ip ospf restart-helper strict-lsa-checking status disable
-> ip ospf restart-helper strict-lsa-checking status enable
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Enables whether or not a changed LSA will result in termination of
graceful restart by a helping router.
Disables whether or not a changed LSA will result in termination of
graceful restart by a helping router.
default
enable
June 2012 page 22-49