IS-IS Commands
ip isis spf-wait
Configures the intervals between the first, second, and subsequent SPF calculations.
ip isis spf-wait {max-wait seconds | initial-wait milliseconds| second-wait milliseconds}
no ip isis spf-wait {max-wait | initial-wait | second-wait}
Syntax Definitions
max-wait seconds
initial-wait milliseconds
second-wait milliseconds
Defaults
parameter
max-wait seconds
initial-wait milliseconds
second-wait milliseconds
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to restore the default value.
•
Successive SPF calculations are generated at exponentially increasing second-wait interval until a
maximum value is reached.
Examples
-> ip isis spf-wait max-wait 25
-> no ip isis spf-wait initial-wait
Release History
Release 6.2.1; command was introduced.
Related Commands
show ip isis status
OmniSwitch CLI Reference Guide
Specifies the maximum interval between two successive SPF calcula-
tions, in seconds. The valid range is 1–120 seconds.
Specifies the initial SPF calculation delay, in milliseconds. The valid
range is 10–100000 milliseconds.
Specifies the interval between first and second generated SPFs, in milli-
seconds. The valid range is 1–100000 milliseconds.
default
10
1000
1000
Displays the IS-IS status.
June 2012
page 24-17