show ipv6 ospf virtual-link
Displays virtual link information. A virtual link is used to connect OSPFv3 backbone routers that are not
physically contiguous.
show ipv6 ospf virtual-link [router_id]
Syntax Definitions
router_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
N/A
Examples
-> show ipv6 ospf virtual-link
Transit Area
----------------+----------------+------+-------+------+
0.0.0.1
output definitions
Transit Area
Peer Router ID
Intf State
Nbr State
Cost
Release History
Release 6.1.3; command was introduced.
page 23-38
The router ID of the remote end of the virtual link.
Intf
Peer Router ID
State
6.6.6.6
P2P
The area identification for the area assigned to the virtual link.
The destination router identification for the virtual link.
The state of the virtual link with regards to the local router.
The state of the virtual link adjacency.
The cost metric of the route.
Nbr
State
Cost
FULL
2
OmniSwitch CLI Reference Guide
OSPFv3 Commands
June 2012