Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1402

output definitions
Status
Router Id
# Areas
# Interface
Area Border Router
AS Border Router
External Route Tag
SPF Hold (seconds)
SPF Delay (seconds)
MTU Checking
# SPF calculations performed
Last SPF run (seconds ago)
Full state
Loading state
Exchange state
Exstart state
2way state
Init state
Attempt state
Down state
Release History
Release 6.1.3; command was introduced.
page 23-26
Displays whether OSPFv3 is currently enabled or disabled on the
router.
The unique identification for the router.
Number of areas to which the router belongs.
Number of interfaces participating in OSPF
Displays whether the router status is an area router or not.
Displays whether the area Autonomous System Border Router status of
this router is enabled or disabled.
Displays the route tag for this router.
Displays the time in seconds between the reception of an OSPFv3
topology change and the start of a SPF calculation.
Displays the time in seconds between consecutive SPF calculations.
Displays whether Maximum Transfer Unit checking is enabled or dis-
abled. This is set using the
Displays the number of SPF calculation performed.
N/A
Displays the number of neighbor routers that are in Full state.
Displays the number of neighbor routers that are in Loading state.
Displays the number of neighbor routers that are in Exchange state.
Displays the number of neighbor routers that are in Exstart state.
Displays the number of neighbor routers that are in 2way state.
Displays the number of neighbor routers that are in Init state.
Displays the number of neighbor routers that are in Attempt state.
Displays the number of neighbor routers that are in Down state.
ipv6 ospf mtu-checking
OmniSwitch CLI Reference Guide
OSPFv3 Commands
command.
June 2012