Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1462

output definitions
LSP ID
Sequence
Checksum
Lifetime
Version
Pkt Type
Pkt Ver
Attributes
Max Area
SysID Len
Used Len
Alloc Len
Area Address
Supp protocols
IS-Host Name
System ID
IS Neighbors
IPv4 Internal Reach
IP Prefix
Metrics
IPv4 External Reach
level-1 LSP Count
level-2 LSP Count
Release History
Release 6.2.1; command was introduced..
page 24-40
The LSP ID. Indicates the system ID and the pseudo-node ID of the
originating router.
The sequence number of the LSP. The Sequence number is a value used
to identify old and duplicate LSPs.
The checksum value of the LSP.
The number of seconds the LSP remains valid. The LSP lifetime value
of zero indicates that this LSP is being removed from the Link State
Database of all the routers.
The version of the IS-IS protocol that has generated the LSP.
The IS-IS PDU type number derived from the PDU header, which can be
18 or 20. The number 18 represents L1 LSP PDU type and 20 represents
L2 LSP PDU type.
The version of
the IS-IS protocol that has generated the packet.
The level capability of the router.
The Maximum number of areas supported by the originating router of the
LSP.
The length of the system-id as used by the originating router.
The length used by the LSP.
The length allocated for the LSP to be stored.
The area ID of the router.
The network layer protocols that are supported.
The host name of the router.
The system ID of the adjacent router. The system ID is a fixed size, six
octet field in the NSAP. In an IS-IS routing domain, each router is iden-
tified by a 6-octet hexadecimal system ID.
The list of reachable IS-IS neighbors.
The list of IS-IS internal routes.
The IP address and subnet mask of the destination.
The metric value to reach the destination.
The list of external IS-IS routes.
The number of Level-1 LSPs.
The number of Level-2 LSPs.
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012