show ip ospf
Displays the OSPF status and general configuration parameters.
show ip ospf
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display the general configuration parameters of the OSPF router.
•
See the Related Commands section below to modify the displayed parameters.
Examples
-> show ip ospf
Router Id
OSPF Version Number
Admin Status
Area Border Router?
AS Border Router Status
Route Tag
SPF Hold Time (in seconds)
SPF Delay Time (in seconds)
MTU Checking
# of Routes
# of AS-External LSAs
# of self-originated LSAs
# of LSAs received
External LSDB Limit
Exit Overflow Interval
# of SPF calculations done
# of Incr SPF calculations done
# of Init State Nbrs
# of 2-Way State Nbrs
# of Exchange State Nbrs
# of Full State Nbrs
# of attached areas
# of Active areas
# of Transit areas
# of attached NSSAs
page 22-52
= 10.255.11.242,
= 2,
= Enabled,
= No,
= Disabled,
= 0,
= 10,
= 5,
= Disabled,
= 0,
= 0,
= 0,
= 0,
= -1,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 1,
= 0,
= 0,
= 0
OmniSwitch CLI Reference Guide
OSPF Commands
June 2012