Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1341

OSPF Commands
output definitions
Router Id
OSPF Version Number
Admin Status
Area Border Router?
AS Border Router Status
Route Tag
SPF Hold Time
SPF Delay Time
MTU Checking
# of routes
# of AS-External LSAs
# of self-originated LSAs
# of LSAs received
External LSDB Limit
Exit Overflow Interval
# of SPF calculations done
# of Incr SPF calculations
done
# of Init State Nbrs
# of 2-Way State Nbrs
# of Exchange State Nbrs
# of Full State Nbrs
# of attached areas
# of Active areas
# of Transit areas
# of attached NSSAs
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
The unique identification for the router.
The version of OSPF the router is running.
Whether OSPF is currently enabled or disabled on the router.
Whether the router status is an area router or not.
Whether the area Autonomous System Border Router status of this
router is enabled or disabled.
Shows the route tag for this router.
Shows the time in seconds between the reception of an OSPF topology
change and the start of a SPF calculation.
Shows the time in seconds between consecutive SPF calculations.
Shows whether Maximum Transfer Unit checking is enabled or dis-
abled. This is set using the
The total number of OSPF routes known to this router.
The number of external routes learned from outside the router's Auton-
omous System (AS).
The number of times a new Link State Advertisement has been sent
from this router.
The number of times a new Link State Advertisement has been received
by this router.
The maximum number of entries allowed in the external Link State
Database.
The number of seconds the router remains in the overflow state before
attempting to leave it. This is set using the
interval command.
The number of SPF calculations that have occurred.
The number of incremental SPF calculations done.
The number of neighbors in the initialization state.
The number of OSPF 2-way state neighbors on this router.
The number of neighbors in the exchange state.
The number of neighbors in the full state.
The number of areas that are configured on the router.
The number of areas that are active.
The number of transit areas that are configured on the router.
The number of Not So Stubby Areas that are configured on the router.
June 2012
ip ospf mtu-checking command.
ip ospf exit-overflow-
page 22-53