Show Ip Ospf Virtual-Neighbor - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip ospf virtual-neighbor

Displays OSPF virtual neighbors. A virtual neighbor is connected to the router via a virtual link rather than
a physical one.
show ip ospf virtual-neighbor area_id router_id
Syntax Definitions
area_id
router_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display all virtual neighbors for the OSPF router.
•
See the Related Commands section below to modify the list.
Examples
-> show ip ospf virtual-neighbor 0.0.0.0 10.0.0.1
AreaId
-----------------+----------------+--------+------+--------+---------+-------
0.0.0.0
output definitions
AreaId
RouterId
Priority
Events
RxmtQlen
LastHello
State
page 22-70
A unique 32-bit value in IP address format.
A unique 32-bit value, such as an IP address, that identifies the config-
ured OSPF area in the AS.
RouterId Priority Events RxmtQLen LastHello
10.0.0.1 1
The area identification for the area of which the virtual neighbor is a
part.
The router identification of the virtual neighbor.
The number used to determine whether the virtual neighbor will
become the designated router for its area.
The number of OSPF control message sent by the neighbor to the
router.
The length (in number of packets) of the retransmit queue.
The last Hello message sent by the neighbor
The current state the virtual neighbor is in relative to the router; this
will be INIT, Exchange, or Full.
10 100 323
OmniSwitch CLI Reference Guide
OSPF Commands
State
INIT
June 2012