Ip Isis Auth-Check - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

ip isis auth-check

Enables or disables authentication check for IS-IS PDUs.
ip isis auth-check {enable | disable}
Syntax Definitions
enable
disable
Defaults
By default, authentication check is enabled.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
If enabled, IS-IS PDUs that fail to match either of the authentication type and key requirements are
rejected.
•
If disabled, the authentication PDUs are generated and the IS-IS PDUs are authenticated on receipt. An
error message will be generated in case of a mismatch; but PDUs will not be rejected.
Examples
-> ip isis auth-check enable
-> ip isis auth-check disable
Release History
Release 6.3.1; command was introduced;
Related Commands
ip isis auth-type
ip isis level auth-type
show ip isis status
MIB Objects
vRtrIsisTable
vRtrIsisAuthCheck
page 24-8
Enables authentication check for IS-IS PDUs.
Disables authentication check for IS-IS PDUs.
Enables authentication and configures the authentication type of IS-
IS protocol globally.
Enables authentication and configures the authentication types for
specific IS-IS levels.
Displays the IS-IS status.
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012