Show Ip Ospf Virtual-Link - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

show ip ospf virtual-link

Displays virtual link information. A virtual link is used to connect OSPF backbone routers that are not
physically contiguous.
show ip ospf virtual-link [router_id]
Syntax Definitions
router_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
See the Related Commands section below to modify the list.
Examples
-> show ip ospf virtual-link
Transit AreaId
----------------+----------------+----------------+----------+------------
1.1.1.1
output definitions
Transit AreaId
Router-Id
State Link
State Adjacency
AuthType
OperStatus
Release History
Release 6.1; command was introduced.
page 22-68
The router ID of the remote end of the virtual link that is to be viewed.
Router-id Link / Adjacency
172.17.1.1 P2P
The area identification for the area assigned to the virtual link.
The destination router identification for the virtual link.
The state of the virtual link with regards to the local router.
The state of the virtual link adjacency.
The type of authorization employed by the virtual link.
Displays whether the virtual link is enabled or disabled.
State
AuthType
/ Full none
OmniSwitch CLI Reference Guide
OSPF Commands
OperStatus
up
June 2012