OSPF Commands
ip ospf restart-helper status
Administratively enables and disables the capability of an OSPF router to operate in helper mode in
response to a router performing a graceful restart.
ip ospf restart-helper [status {enable | disable}]
Syntax Definitions
enable
disable
Defaults
parameter
enable | disable
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
The minimum hardware configuration for this command is a redundant CMM configuration. This
command is not supported on OmniSwitch chassis-based switches with a single CMM or OmniSwitch
stackable switches in a standalone configuration.
•
On OmniSwitch 6850 switches, a graceful restart is supported only on active ports (i.e., interfaces) that
are on the secondary or idle modules in a stack during a takeover. It is not supported on ports on a
primary switch in a stack.
Examples
-> ip ospf restart-helper status disable
-> ip ospf restart-helper status enable
Release History
Release 6.1; command was introduced.
OmniSwitch CLI Reference Guide
Enables the capability of an OSPF router to operate in helper mode.
Disables the capability of an OSPF router to operate in helper mode.
default
enable
June 2012
page 22-47