ip load isis
Loads the IS-IS software on the router.
ip load isis
Syntax Definitions
N/A
Defaults
By default, IS-IS is not loaded on the switch.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
You need to load IS-IS on the switch before executing any IS-IS configuration command.
•
To unload IS-IS, remove all the IS-IS configuration from "boot.cfg".
Examples
-> ip load isis
Release History
Release 6.2.1; command was introduced.
Related Commands
show ip protocols
MIB Objects
alaDrcTmIPIsisStatus
page 24-4
Displays switch routing protocol information and status.
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012