Show Ip Ospf Area - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPF Commands

show ip ospf area

Displays either all OSPF areas, or a specified OSPF area.
show ip ospf area [area_id]
Syntax Definitions
area_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
Allows you to view the details of a specified OSPF area.
•
Not specifying an OSPF area will display all known areas for the OSPF router.
•
See the Related Commands section below for information on modifying an area.
Examples
-> show ip ospf area
Area Id
---------------+-------------+-------------+------------
1.1.1.1
0.0.0.1
-> show ip ospf area 0.0.0.0
Area Identifier
Admin Status
Operational Status
Area Type
Area Summary
Time since last SPF Run
# of Area Border Routers known
# of AS Border Routers known
# of LSAs in area
# of SPF Calculations done
# of Incremental SPF Calculations done
# of Neighbors in Init State
# of Neighbors in 2-Way State
# of Neighbors in Exchange State
# of Neighbors in Full State
# of Interfaces attached
Attached Interfaces
OmniSwitch CLI Reference Guide
A unique 32-bit value in IP address format.
AdminStatus Type
disabled normal
disabled normal
June 2012
OperStatus
down
down
= 1.1.1.1,
= Disabled,
= Down,
= normal,
= Enabled,
= 00h:00m:27s,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0
= vlan-213
page 22-73