Ipv6 Ospf Spf-Timer - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPFv3 Commands

ipv6 ospf spf-timer

Configures timers for Shortest Path First (SPF) calculation.
ipv6 ospf spf-timer [delay delay_seconds] [hold hold_seconds]
Syntax Definitions
delay_seconds
hold_seconds
Defaults
parameter
delay_seconds
hold_seconds
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command allows you to configure the time interval between SPF calculations.
•
Use the delay timer to determine how much time to postpone an SPF calculation after the router
receives a topology change.
•
Use the hold timer to configure the amount of time that must elapse between consecutive SPF calcula-
tions.
•
There will be no delay in the SPF calculation if either the delay timer or hold timer is set to 0. The SPF
calculations will occur immediately upon the reception of a topology change and/or that back-to back
SPF calculations can take place with no break in-between the two.
Examples
-> ipv6 ospf spf-timer delay 20 hold 35
Release History
Release 6.1.3; command was introduced.
OmniSwitch CLI Reference Guide
Specifies time (from 0 to 65535 seconds) between the reception of an
OSPF topology change and the start of an SPF calculation.
Specifies the minimum time (from 0 to 65535 seconds) between consec-
utive SPF calculations.
default
5
10
June 2012 page 23-9