Show Ip Ospf Ext-Lsdb - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPF Commands

show ip ospf ext-lsdb

Displays external Link State Advertisements known by this router.
show ip ospf ext-lsdb [linkstate-id ls_id] [router-id router_id]
Syntax Definitions
ls_id
router_id
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display the external link state database (LSDB) for the OSPF router.
•
This command can be used for OSPF debugging purposes, specifically to narrow down sections of
attached areas to determine which sections are receiving the specified external LSAs. You may specify
only the parameters from the area LSDB in which you are interested using the optional command
parameters.
•
See the Related Commands section below to modify the list.
Examples
-> show ip ospf ext-lsdb
LS Id
-----------------+------------------+----------+--------+----------
198.168.100.100
output definitions
LS Id
Orig Router-Id
SeqNo
Age
Protocol
OmniSwitch CLI Reference Guide
The Link state ID. The ID is a unique 32-bit value such as an IP
address. This number is used as a record in the link state database.
The Router ID. The ID is a unique 32-bit value such as an IP address.
Orig Router-Id SeqNo
198.168.100.100
The Link state ID. The ID is a unique 32-bit value, such as an IP
address. This number is used as a record in the link state database.
The router ID of the router that originated the external LSDB.
The advertisement sequence number (i.e., a value used to identify old
and duplicate link state advertisements).
The age of the LSA in seconds. That is, the duration for which this
entry has existed in the external database.
The type of protocol, if any.
June 2012
Age Protocol
10 100 STATIC
page 22-57