OSPFv3 Commands
show ipv6 ospf
Displays the OSPFv3 status and general configuration parameters.
show ipv6 ospf
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display the general configuration parameters of the OSPFv3 router.
•
See the Related Commands section below to modify the displayed parameters.
Examples
-> show ipv6 ospf
Status
Router ID
# Areas
# Interfaces
Area Border Router
AS Border Router
External Route Tag
SPF Hold (seconds)
SPF Delay (seconds)
MTU checking
# SPF calculations performed
Last SPF run (seconds ago)
# of neighbors that are in:
Full state
Loading state
Exchange state
Exstart state
2way state
Init state
Attempt state
Down state
OmniSwitch CLI Reference Guide
= Enabled,
= 5.5.5.5,
= 2,
= 4,
= Yes,
= No,
= 0,
= 10,
= 5,
= Enabled,
= 3,
= N/A,
= 3,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
= 0,
June 2012
page 23-25