ip isis area-id
Configures the area ID for the switch.
ip isis area-id area address
no ip isis area-id area address
Syntax Definitions
area address
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to remove the area ID.
•
The area ID is part of the Network Service Access Point (NSAP) address.
•
Other parts of NSAP address (system ID and selector ID) are not configurable. System ID is derived
from router ID and selector ID remains always as 00.
•
You can configure a maximum of three area addresses.
Examples
-> ip isis area-id 49.0001
-> no ip isis area-id 49.0001
Release History
Release 6.2.1; command was introduced.
Related Commands
show ip isis status
MIB Objects
isisManAreaAddrTable
isisManAreaAddrExistState
page 24-6
1–13 byte variable length integer, which specifies the area address.
Displays the IS-IS status.
OmniSwitch CLI Reference Guide
IS-IS Commands
June 2012