Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1370

The following is an example of simple authentication (an interface name is used in this example):
-> show ip ospf interface vlan-3
Interface IP Name
VLAN Id
Interface IP Address
Interface IP Mask
Admin Status
Operational Status
OSPF Interface State
Interface Type
Area Id
Designated Router IP Address
Designated Router RouterId
Backup Designated Router IP Address
Backup Designated Router RouterId
MTU (bytes)
Metric Cost
Priority
Hello Interval (seconds)
Transit Delay (seconds)
Retrans Interval (seconds)
Dead Interval (seconds)
Poll Interval (seconds)
Link Type
Authentication Type
Authentication Key
# of Events
# of Init State Neighbors
# of Exchange State Neighbors
# of 2-Way State Neighbors
# of Full State Neighbors
BFD Status
DR-Only Option for BFD
Output fields when an interface name is specified are described below:
output definitions
Interface IP Name
VLAN Id
Interface IP Address
Interface IP Mask
Admin Status
Operational Status
OSPF Interface State
Interface Type
Area Id
Designated Router IP Address The designated router IP address.
page 22-82
= vlan-3
= 3,
= 100.10.10.2,
= 255.255.255.0,
= Enabled,
= Up,
= DR,
= Broadcast,
= 0.0.0.2,
= 100.10.10.2,
= 192.169.1.2,
= 0.0.0.0,
= 0.0.0.0,
= 1500,
= 1,
= 1,
= 10,
= 1,
= 5,
= 40,
= 120,
= Broadcast,
= simple,
= Set,
= 3,
= 0,
= 0,
= 0,
= 0
= Disabled,
= Disabled
The name of the IP interface to which the OSPF interface is assigned.
The VLAN to which the interface is assigned.
The IP address assigned to the interface.
The IP mask associated with the IP address assigned to the interface.
The current administration status of the interface, either enabled or
disabled.
Whether the interface is an active OSPF interface.
The current state of the OSPF interface. It will be down, up, dp, dr, or
other.
The OSPF interface type, which can be Broadcast, NBMA, Point-to-
Point, or Point-to-Multipoint.
The area identification number to which the interface is assigned. This
field is not applicable if an interface has not yet been assigned to an
area.
OmniSwitch CLI Reference Guide
OSPF Commands
June 2012