Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual page 1369

OSPF Commands
The following is an example of MD5 authentication (an interface name is used in this example).
-> show ip ospf interface vlan-3
Interface IP Name
VLAN Id
Interface IP Address
Interface IP Mask
Admin Status
Operational Status
OSPF Interface State
Interface Type
Area Id
Designated Router IP Address
Designated Router RouterId
Backup Designated Router IP Address
Backup Designated Router RouterId
MTU (bytes)
Metric Cost
Priority
Hello Interval (seconds)
Transit Delay (seconds)
Retrans Interval (seconds)
Dead Interval (seconds)
Poll Interval (seconds)
Link Type
Authentication Type
# Id Key Status
--+----+-----+----------+-----------+-----------+---------+--------
1 1 Set Enabled
# of Events
# of Init State Neighbors
# of 2-Way State Neighbors
# of Exchange State Neighbors
# of Full State Neighbors
BFD Status
DR-Only Option for BFD
Note. See the table of the following page for output definitions.
OmniSwitch CLI Reference Guide
= vlan-3
= 3,
= 100.10.10.2,
= 255.255.255.0,
= Enabled,
= Up,
= BDR,
= Broadcast,
= 0.0.0.2,
= 100.10.10.88,
= 100.10.10.88,
= 100.10.10.2,
= 192.169.1.2,
= 1500,
= 1,
= 1,
= 10,
= 1,
= 5,
= 40,
= 120,
= Broadcast,
= md5,
StartAccept StopAccept
0 0
= 2,
= 0,
= 0,
= 0,
= 1
= Disabled,
= Disabled
June 2012
StartGen StopGen
0 0
page 22-81