Ip Ospf Interface Hello-Interval - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPF Commands

ip ospf interface hello-interval

Configures the OSPF interface hello interval.
ip ospf interface {interface_name} hello-interval seconds
Syntax Definitions
interface_name
seconds
Defaults
parameter
seconds
(broadcast and point-to-point)
seconds
(NBMA and point-to-multi-
point)
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
This is the interval between two consecutive hello packets sent out on this interface.
Examples
-> ip ospf interface vlan-101 hello-interval 50
Release History
Release 6.1; command was introduced.
Release 6.2.1; ip_address parameter deprecated.
Related Commands
show ip ospf interface
MIB Objects
ospfIfTable
ospfIfHelloInterval
OmniSwitch CLI Reference Guide
The name of the interface.
The hello interval, in seconds. The valid range is 0–65535. A value of 0
creates a passive OSPF interface.
default
10
30
Displays the status and statistics of an OSPF interface.
June 2012 page 22-33