Show Ip Ospf Border-Routers - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

OSPF Commands

show ip ospf border-routers

Displays information regarding all or specified border routers.
show ip ospf border-routers [area_id] [router_id] [tos] [gateway]
Syntax Definitions
area_id
router_id
tos
gateway
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display a list of border routers known by this OSPF router.
•
By using the optional parameters, you can display the border routers using the specified parameter. For
example, to find a router using a router ID of 1.1.1.1, enter the command using the router ID of 1.1.1.1
as a search criteria.
•
See the related commands sections below to modify the list.
Examples
-> show ip ospf border-routers 10.0.0.0
Router Id
-----------------+------------------+--------------------+------+--------
10.0.0.0
output definitions
Router ID
Area ID
Gateway
ToS
Metric
OmniSwitch CLI Reference Guide
A unique 32-bit value in IP address format.
A unique 32-bit value, such as an IP address, that identifies a neighbor-
ing router in the Autonomous System.
The Type of Service. The valid range is 0–15. Only ToS value 0 is
supported at this time.
The 32-bit IP address of the gateway for the border router being
displayed.
Area Id
1.0.0.1
The unique identification for the router.
A unique 32-bit value, such as an IP address, that identifies a neighbor-
ing router in the Autonomous System.
The next hop interface on which the border router has been learned.
The Type of Service. Only ToS value 0 is supported at this time.
The cost to the border router.
June 2012
Gateway TOS
143.209.92.71
Metric
1 1
page 22-55