Ip Isis Overload - Alcatel-Lucent OmniSwitch 6850-48 Cli Reference Manual

IS-IS Commands

ip isis overload

Enables and configures the IS-IS router to operate in the overload state for a specified time period.
ip isis overload [timeout seconds]
no ip isis overload [timeout]
Syntax Definitions
timeout seconds
Defaults
By default, the IS-IS overload state is disabled.
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to make the router exit the overload state.
•
If the time period is not specified, the router remains in the overload state for an infinite period.
•
During normal operation, the router may be forced to enter an overload state due to a lack of resources.
When in the overload state, the router is used only if the destination route is directly reachable by the
router i.e., it will not be used for other transit traffic.
•
This command can be used when the router is overloaded or before executing a shutdown command to
divert traffic around the router.
Examples
-> ip isis overload timeout 70
-> no ip isis overload timeout
Release History
Release 6.2.1; command was introduced..
OmniSwitch CLI Reference Guide
Specifies the timeout interval, in seconds. The valid range is 60–1800.
June 2012 page 24-21