OSPF Commands
show ip ospf neighbor
Displays information on OSPF non-virtual neighbor routers.
show ip ospf neighbor [ip_address]
Syntax Definitions
ip_address
Defaults
N/A
Platforms Supported
OmniSwitch 6850, 6855, 6850E, 9000E
Usage Guidelines
•
This command is used to display all non-virtual neighbors of the OSPF router.
•
See the Related Commands section below to modify the list.
Examples
-> show ip ospf neighbor
IP Address
----------------+----------------+----------------+----+-------+--------
1.1.1.1
output definitions
IP Address
Area Id
Router Id
VlanId
State
Mode
OmniSwitch CLI Reference Guide
A 32-bit IP address of the neighboring router.
Area Id
Router Id
255.255.255.255
0.0.0.0
The IP address of the neighbor.
A unique 32-bit value, such as an IP address, that identifies the neigh-
boring router in the Autonomous System.
The unique identification for the neighboring router.
The VLAN corresponding to this interface on which the neighbor is
reachable.
The state of the OSPF neighbor adjacency.
What type of neighbor, either Dynamic (learned) or Static.
June 2012
Vlan State
Mode
0
Down
Static
page 22-63