IS-IS Commands
ip isis lsp-wait
Configures the intervals between the first, second and subsequently generated LSPs.
ip isis lsp-wait {max-wait | initial-wait | second-wait} seconds
no ip isis lsp-wait {max-wait | initial-wait | second-wait}
Syntax Definitions
max-wait
initial-wait
second-wait
seconds
Defaults
parameter
seconds (max-wait)
seconds (initial-wait)
seconds (second-wait)
Platforms Supported
OmniSwitch 6850, 6850E, 9000E
Usage Guidelines
•
Use the no form of this command to restore the default value.
•
Successive LSPs are generated at increasing second-wait interval until a maximum value is reached.
Examples
-> ip isis lsp-wait max-wait 25
-> no ip isis lsp-wait initial-wait
Release History
Release 6.2.1; command was introduced.
OmniSwitch CLI Reference Guide
Specifies the maximum interval between two successive LSPs, in
seconds. The valid range is 1–120.
Specifies the initial LSP generation delay, in seconds. The valid range is
0–100.
Specifies the time interval between the first and second generated LSPs,
in seconds. The valid range is 1–100.
Specifies the time interval.
default
5
0
1
June 2012
page 24-15