Omron ACCURAX G5 User Manual page 8

Safety Precautions Document
Do not place flammable materials near the motor, driver or Regeneration Resistor.
Fire may result.
Install the motor, driver and Regeneration Resistor to non-flammable materials such as
metals.
Fire may result.
When you perform a system configuration using the safety function, be sure to fully
understand the relevant safety standards and the descriptions in the operation manual, and
apply them to the system design.
Injury or damage may result.
Do not use the cable when it is laying in oil or water.
Electric shock, injury or fire may result.
Never connect a commercial power supply directly to the motor.
Fire or failure may result.
Do not perform wiring or any operation with wet hands.
Electric shock, injury or fire may result.
Do not touch the key grooves with bare hands if a motor with shaft-end key grooves is being
used.
Injury may result.
Use the motor and driver in the specified combination.
Fire or equipment damage may result.
Do not store or install the product in the following environment:
Location subject to direct sunlight
Location where the ambient temperature exceeds the specified level
Location where the relative humidity exceeds the specified level
Location subject to condensation due to the rapid temperature change
Location subject to corrosive or flammable gases
Location subject to higher levels of dust, salt content or iron dust
Location subject to splashes of water, oil, chemicals, etc.
Location where the product may receive vibration or impact directly
Installing or storing the product in these locations may result in fire, electric shock or
equipment damage.
The driver radiator, Regeneration Resistor, motor, etc. may become hot while the power is
supplied or remain hot for a while even after the power supply is cut off. Never touch these
components.
A burn injury may result.
6 Accurax G5 AC SERVOMOTOR AND SERVO DRIVE USER'S MANUAL
Danger
Caution