Reset Default Ssids And Pre-Shared Keys For The Preconfigured Wi-Fi Access Points - Digi TX54 User Manual

Configuration and
management
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Set a new password for the admin user. The password must be at least eight characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
(config)> auth user admin password new-password
(config)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Reset default SSIDs and pre-shared keys for the preconfigured
Wi-Fi access points
By default, the SSIDs and pre-shared keys for the preconfigured Wi-Fi access points are:
Enabled
n
SSID: Digi-TX54-serial_number
n
Encryption: WAP2 Personal (PSK)
n
Pre-shared key: The unique password printed on the bottom label of the device.
n

WebUI
1. Log into the TX54 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
TX54 User Guide
Reset default SSIDs and pre-shared keys for the preconfigured Wi-Fi access
points
44