Table of Contents
Advertisement
Virtual Private Networks (VPN)
12. Save the configuration and apply the change:
(config vpn openvpn client openvpn_client1 connection_monitor target 0)>
save
Configuration saved.
>
13. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
See
Show Surelink status and statistics
clients.
Show OpenVPN server status and statistics
You can view status and statistics for OpenVPN servers from either the web interface or the command
line:
Web
1. Log into the IX10 WebUI as a user with Admin access.
2. On the menu, select Status > OpenVPN > Servers.
The OpenVPN Servers page appears.
3. To view configuration details about an OpenVPN server, click the (configuration) icon in the
upper right of the OpenVPN server's status pane.
Command line
1. Select the device in Remote Manager and click Actions > Open Console, or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. To display details about all configured OpenVPN servers, type the following at the prompt:
> show openvpn server all
Server
---------------
OpenVPN_server1
OpenVPN_server2
>
IX10 User Guide
(config vpn openvpn client openvpn_client1 surelink target
0)>
where value is either up or down. For example, if other_status is set to
down, but the alternate interface is determined to be up, then this test will
fail.
for information about showing Surelink status for OpenVPN
Enable
Type
Zone
------
----
--------
true
tun
internal
false
tun
internal
IP Address
Port
---------------
----
192.168.30.1/24
1194
192.168.40.1/24
1194
OpenVPN
342
Advertisement
Table of Contents
