Ambient Light; Turn Signal Indicators; Circuit Breakers And Fuses - MacDon M105 Operator's Manual

Ambient Light

To replace the ambient light fixture, follow these steps:
1. Shut down engine.
2. Locate the ambient light fixture (A) in the roof liner.
3. Push against tabs (A) with a screwdriver and pull
ambient light fixture out of cab roof.
4. Remove wires from connectors (B).
5. Connect wires to new light fixture.
6. Push into place in cab roof until tabs hold fixture
in place.

Turn Signal Indicators

If the turn signal indicators on the cab display module (CDM) do NOT function, contact your MacDon Dealer.

Circuit Breakers and Fuses

The circuit breakers and fuses are located inside a fuse box mounted on the right (cab-forward) side of the frame.
The circuit breakers automatically reset. Fuses are the plastic blade type.
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
Access the breakers and fuses as follows:
1. Stop engine and remove key.
169890
MAINTENANCE AND SERVICING
282
Figure 5.164: Ambient Light Fixture
Figure 5.165: Ambient Light Fixture
Revision A