Checking And Adding Wheel Drive Lubricant Level - MacDon M155 Unloading And Assembly Instructions

5.2 Checking and Adding Wheel Drive Lubricant Level

1. Park the windrower on level ground.
2. Position windrower so plugs (A) and (B) are horizontally
aligned with the center (C) of the hub.
3. Stop the engine, and remove the key.
4. Remove plug (A) or (B). The lubricant should be visible
through the port or running out slightly.
5. If lubricant needs to be added, remove the second
plug (A) or (B), and add lubricant until lubricant runs out
from the other port (A). For lubricant specifications,
refer to the inside back cover of this book.
NOTE:
The type of lubricant used after the first lubricant
change is different from the factory-supplied lubricant.
6. Reinstall plugs and tighten.
214298
PERFORMING PREDELIVERY CHECKS
216
Figure 5.3: Drive Wheel Hub
Revision A