Chapter 18
Power Over Ethernet (PoE) Commands
"DISABLE POE PORT" on
page 334
"ENABLE POE PORT" on
page 335
"SET POE DETECT" on
page 336
"SET POE GUARDBAND" on
page 337
"SET POE MANAGEMENT" on
page 338
"SET POE PORT" on page 339
"SET POE THRESHOLD" on
page 341
"SHOW POE" on page 342
"SHOW POE PORT" on
page 343
Section III: Layer 2 Switching
The PoE commands are summarized in Table 36.
Table 36. PoE Commands
Command
AT-GS900M Series CLI Reference
Description
Disables Power of Ethernet (PoE) on
ports.
Enables PoE on ports.
Detects IEEE compliant and legacy PDs.
Specifies guard power in watts.
Specifies the power management mode to
the switch.
Specifies the power supply priority and
power limit on the ports.
Specifies the threshold that the switch
supplies to the connected PDs.
Displays information about PoE settings
and ports.
Displays information about PoE ports.
333