Power Over Ethernet Commands; Introduction; Chapter 16: Power Over Ethernet Commands - Allied Telesis CentreCOM GS948MPX Command Reference Manual

16

Introduction

Overview This chapter contains an alphabetical list of commands used to configure Power
over Ethernet (PoE). Each command contains a functional description and shows
examples of configuration and output screens for show commands. These
commands are only supported on PoE capable ports. An error message will display
on the console if you enter a PoE command on a port that does not support PoE.
The following documents offer further information for configuring PoE on
AlliedWare Plus switches.
•
•
•
Power over Ethernet (PoE) is a technology allowing devices such as security
cameras to receive power over LAN cabling.
The Powered Device (PD) referred to throughout this chapter is a PoE or PoE+
powered device, such as an IP phone or a Wireless Access Point (WAP).
Command List •
•
•
•
•
•
•
•
•
C613-50181-01 Rev B
the PoE Feature Overview and
the Support for Allied Telesis Enterprise_MIBs_in AlliedWare
information about which PoE MIB objects are supported.
the SNMP Feature Overview and
SNMP traps.
"clear power-inline counters
"debug power-inline" on page 566
"power-inline allow-legacy" on page 568
"power-inline description" on page 569
"power-inline enable" on page 570
"power-inline max" on page 571
"power-inline priority" on page 573
"power-inline usage-threshold" on page 575
"service power-inline" on page 576
Command Reference for GS900MX Series
AlliedWare Plus™ Operating System - Version 5.4.7-1.x
Power over
Ethernet
Commands
Configuration_Guide.
Configuration_Guide, for information about
interface" on page 565
Plus, for
563