Inspecting The Gearbox, Back Lash - ABB IRT 710 Product Manual

4 Maintenance

4.3.10 Inspecting the gearbox, back lash

4.3.10 Inspecting the gearbox, back lash
Location of gearbox
The gearbox is located as shown in figure.
xx2200000615
A
B
Required equipment
Equipment, etc.
Standard toolkit
Inspecting the gearbox, back lash
Use this procedure to inspect the gearbox, back lash.
1
Continues on next page
200
Motor
Gearbox
Action
The first step is to listen for abnormal noise
when running. Then witness the appear-
ance of the reducer, the appearance of the
gear and the grease lubrication. There
should be no cracks in the appearance, the
gears are well lubricated, and the teeth are
not severely worn. If there is wear, you
need to check backlash in time. Contamin-
ated grease requires cleaning and re-oiling
Check that there is no abnormal noise
when running.
© Copyright 2023 ABB. All rights reserved.
Art. no.
-
Note
See Adjusting the gearbox and rack back-
lash on page
Note
Content is defined in section
Standard toolkit on page
230.
Product manual - IRT 710
3HKA00000186299-001 Revision: B
372.