ABB IRT 710 Product Manual page 252

5 Repair
5.2.4 Replacing the lubrication parts
Continued
Refitting the grease pump
Use this procedure to refit the grease pump.
Refitting the grease pump
1
2
3
4
Concluding procedure
1
Replacing the grease detection sensor
Removing the grease detection sensor
Use this procedure to remove the grease detection sensor.
Preparations before removing the grease detection sensor
1
2
Continues on next page
252
Action
Refit the pump unit and tighten the screw.
Connect the tubes.
Connect the connector:
• 24V
Check that the lubrication system can work
normally.
Action
DANGER
Make sure all safety requirements are met when
performing the first test run. See
may cause injury or damage on page
Action
If there is no enough space for the maintenance
work, clean the surroundings.
If there is any robot on the track, jog it to the lift-
ing/transportation position.
© Copyright 2023 ABB. All rights reserved.
Note
xx2200000821
Note
First test run
29.
Note
3HKA00000186299-001 Revision: B
Product manual - IRT 710