ABB IRT 710 Product Manual page 125

16
17
18
19
Product manual - IRT 710
3HKA00000186299-001 Revision: B
Action
Release the carriage brake and push the carriage
manually to check the rails alignment: if the rails
are correctly aligned, you should sense no "step"
while passing the rails junction. If so then push
downward the rail against the side member
shoulder and verify the 0.2 mm gap between rails.
Tip
For more information on moving carriage manu-
ally, see Moving the carriage manually on page
When the alignment is correct, tighten the rail
screws one by one, after applying Loctite 243 on
their thread.
Use a brush to lubricate the rails.
Secure the rack by slightly tighten the locking
screws
Note
Check that the chamfer is located in front of the
side member step (check on preassembled sec-
tion if you are not sure).
© Copyright 2023 ABB. All rights reserved.
3 Installation and commissioning
3.4.7.1 Assembling the sections
Note/Illustration
117.
Tightening torque: 128 Nm ±3%
xx2200000834
xx2200001170
xx2200001171
Continues on next page
Continued
125